REMOVAL
Removal / installation · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)
|
 |
- Disengage the 14 claws and remove the front door scuff plate.
| 3.
REMOVE COWL SIDE TRIM BOARD RH (for RHD)
|
 |
- Remove the clip.
Disengage the 2 claws and remove the cowl side trim board.
| 4.
SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH (for RHD)
|
 |
Separate the front door opening trim weatherstrip RH.
| 5.
REMOVE NO.1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)
|
 |
- Disengage the 4 clips and 2 claws and remove the instrument panel register.
- NOTICE:
- To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
- Pull the instrument panel register up diagonally to remove it.
| 6.
SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for RHD)
|
 |
- Disengage the 3 claws and separate the hood lock control lever.
| 7.
SEPARATE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for RHD)
|
 |
- Disengage the 3 claws and separate the fuel lid lock open lever.
| 8.
REMOVE INSTRUMENT PANEL FINISH PLATE (for RHD)
|
 |
- Using a screwdriver with its tip wrapped in protective tape, remove the instrument panel finish plate.
Text in Illustration
*1
|
Protective Tape
|
*2
|
Instrument Panel Finish Plate
|
| 9.
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for RHD)
|
 |
- Remove the 2 <E> bolts.
Disengage the 8 clips and 4 guides.
Disconnect the connectors and remove the lower instrument panel finish panel.
| 10.
REMOVE IGNITION SWITCH ASSEMBLY (for LHD) |
 |
Disconnect the connector.
Remove the 2 screws, then remove the ignition switch.
| 11.
REMOVE IGNITION SWITCH ASSEMBLY (for RHD) |
 |
Disconnect the connector.
Disconnect the connector clamp from the ignition switch.
- Remove the 2 screws, then remove the ignition switch.