2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

  1. B130597
    Disengage the 14 claws and remove the front door scuff plate.


3. REMOVE COWL SIDE TRIM BOARD RH (for RHD)

  1. B130599
    Remove the clip.

  1. Disengage the 2 claws and remove the cowl side trim board.


4. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH (for RHD)
  1. Separate the front door opening trim weatherstrip RH.


5. REMOVE NO.1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)

  1. B133853
    Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.


6. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for RHD)

  1. B133859
    Disengage the 3 claws and separate the hood lock control lever.


7. SEPARATE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for RHD)

  1. B267057
    Disengage the 3 claws and separate the fuel lid lock open lever.


8. REMOVE INSTRUMENT PANEL FINISH PLATE (for RHD)

  1. E149562E03
    Using a screwdriver with its tip wrapped in protective tape, remove the instrument panel finish plate.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Instrument Panel Finish Plate


9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for RHD)

  1. B267058
    Remove the 2 <E> bolts.

  1. Disengage the 8 clips and 4 guides.

  1. Disconnect the connectors and remove the lower instrument panel finish panel.


10. REMOVE IGNITION SWITCH ASSEMBLY (for LHD)

A242670
  1. Disconnect the connector.

  1. Remove the 2 screws, then remove the ignition switch.


11. REMOVE IGNITION SWITCH ASSEMBLY (for RHD)

A242641
  1. Disconnect the connector.

  1. Disconnect the connector clamp from the ignition switch.

  1. A242640
    Remove the 2 screws, then remove the ignition switch.

← REMOVAL (Nov 2010 – Jul 2012)INSPECTION (from Jul 2007) →