2011-2016 FJ Cruiser · Service Manual COMMUNICATION SYSTEM

Steering Angle Sensor Communication Stop Mode

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
Steering Angle Sensor Communication Stop Mode
  1. "STEERING_SENSOR" not displayed on "BUS CHECK" screen of Techstream via CAN VIM
  2. Applies to "Steering Angle Sensor Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of steering angle sensor
  2. Steering angle sensor branch wire or connector
  3. Steering angle sensor

WIRING DIAGRAM

C132875E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

    HINT:
    Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION

  1. C133843E02
    Turn the ignition switch OFF.

  1. Disconnect the E16 steering angle sensor connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-3 (CANH) - E16-11 (CANL)
    Ignition switch OFF
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO STEERING ANGLE SENSOR (CAN-H, CAN-L)
OK


2. CHECK HARNESS AND CONNECTOR

  1. C133843E03
    Disconnect the E16 steering angle sensor connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-2 (ESS) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E16-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STEERING ANGLE SENSOR (Click here)


← Skid Control ECU Communication Stop Mode (from Nov 2010)Steering Angle Sensor Communication Stop Mode (from Nov 2010) →