2011-2016 FJ Cruiser · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jul 2007

HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT ARMREST BASE UPPER PANEL

  1. B135565
    Disengage the 3 claws and clip and remove the front armrest base upper panel.

  1. Disconnect the connector.


3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side (Click here).


4. REMOVE NO. 2 FRONT DOOR SERVICE HOLE COVER

HINT:
Use the same procedure as for the RH side (Click here).


5. REMOVE OUTER REAR VIEW MIRROR

B135564
  1. Driver side:
    Provisionally install the power window regulator master switch.

  1. Passenger side:
    Provisionally install the power window regulator switch.

  1. Close the door glass.

  1. Disconnect the connector.

  1. Remove the 3 bolts and the outer rear view mirror.

    NOTICE:
    Do not drop or damage the outer rear view mirror when removing the bolts.

  1. B140036E01
    Apply protective tape to the lower part of the mirror body.

  1. Press down the upper part of the mirror and tilt the mirror.

  1. B140035E01
    Using a screwdriver with its tip wrapped in protective tape, insert it between the mirror holder and the mirror holder base.

  1. B138150E01
    Twist and disengage the 2 clips on the lower side of the mirror.

    HINT:
    Heating the mirror holder with a domestic dryer before this procedure makes the work easier.

  1. While holding the mirror with the screwdriver, disengage the 4 clips and 2 claws on the upper side of the mirror and remove the mirror.

  1. Driver side:
    Remove the power window regulator master switch.

  1. Passenger side:
    Remove the power window regulator switch.


6. REMOVE OUTER REAR VIEW MIRROR ILLUMINATION LIGHT BULB (w/ Illumination)

E127190
  1. Turn the outer rear view mirror illumination light socket and bulb, in the direction indicated by the allow in the illustration, to remove them.

  1. Remove the outer rear view mirror illumination light bulb from the light socket.

← COMPONENTS (from Jul 2007)INSPECTION (from Jul 2007) →