2011-2016 FJ Cruiser · Service Manual DRIVE LINE

DISASSEMBLY

Removal / installation · Vehicles built from Jul 2007


1. INSPECT REAR PROPELLER SHAFT ASSEMBLY
  1. Check that the propeller shaft is not damaged or deformed.
    If necessary, replace the propeller shaft.

  1. C029928
    Using a dial indicator, check the propeller shaft runout.

    Maximum runout:
    0.3 mm (0.012 in.)

    If the shaft runout is greater than the maximum, replace the propeller shaft.


2. INSPECT UNIVERSAL JOINT SPIDER BEARING
  1. Check that the joints move smoothly.

  1. Check the spider bearings for wear and damage.

  1. Check the spider bearing axial play by turning the yoke while holding the shaft tightly.

    Maximum bearing axial play:
    0 mm (0 in.)

    If necessary, replace the spider bearing.


3. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER KIT

  1. F015023E05
    Place matchmarks on the flange yoke and sleeve yoke.

  1. C061264
    Using a brass bar and a hammer, slightly tap in the spider bearing outer races.

  1. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

  1. F015025E05
    Using SST, push out the spider bearing from the propeller shaft.
    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.

  1. F044192E01
    Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

    NOTICE:
    Do not tap the shaft.

    HINT:
    Remove the spider bearings on the opposite side in the same procedure.

  1. F015030E04
    Install the 2 removed spider bearing outer races onto the spider.

  1. Using SST, push out the bearing from the yoke.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.

  1. F044193E03
    Clamp the outer bearing race in a vise and tap off the flange yoke with a hammer.

  1. Remove the spider.

← REMOVAL (from Jul 2007)REASSEMBLY (from Jul 2007) →