2011-2016 FJ Cruiser · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. REMOVE NO. 1 ENGINE UNDER COVER

  1. A217571
    While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.


2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY
  1. Remove the 4 bolts, then remove the rear engine under cover.


3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

C098708E04
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4bolts and 4 washers.

  1. C098709E03
    Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 washers and the propeller shaft assembly.


4. REMOVE FRONT DRIVE PINION COMPANION FLANGE NUT

C089309E01
  1. Using SST and a hammer, loosen the staked part of the nut.

    SST
    09930-00010  

  1. B087842E02
    Using SST to hold the companion flange, remove the nut.
    SST
    09330-00021   (09330-00030)


5. REMOVE FRONT DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY

F040720E01
  1. Using SST, remove the companion flange.

    SST
    09950-30012   (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03020)

    NOTICE:
    Before using SST (center bolt), apply hypoid gear oil to its threads and tip.


6. REMOVE FRONT DIFFERENTIAL CARRIER OIL SEAL

F040717E01
  1. Using SST, remove the oil seal.

    SST
    09308-10010  


7. REMOVE FRONT DIFFERENTIAL DRIVE PINION OIL SLINGER

8. REMOVE FRONT DRIVE PINION REAR TAPERED ROLLER BEARING

F044343E01
  1. Using SST, remove the roller bearing (inner).

    SST
    09556-22010  

  1. W001770E01
    Using SST, tap out the roller bearing (outer).
    SST
    09308-00010  


9. REMOVE FRONT DIFFERENTIAL OIL STORAGE RING
  1. Using a screwdriver and hammer, tap out the oil storage ring.


10. REMOVE FRONT DIFFERENTIAL DRIVE PINION BEARING SPACER
← REMOVAL (Jul 2007 – Jul 2009)INSTALLATION (Jul 2007 – Jul 2009) →