2011-2016 FJ Cruiser · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. REMOVE REAR PROPELLER SHAFT ASSEMBLY

C098699E02
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts and 4 washers.

  1. C098700E02
    Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts, 4 washers and the propeller shaft assembly.


2. REMOVE REAR DRIVE PINION NUT

C089309E01
  1. Using SST and a hammer, loosen the staked part of the nut.

    SST
    09930-00010  

  1. B087842E02
    Using SST to hold the companion flange in place, remove the nut.
    SST
    09330-00021   (09330-00030)


3. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY

F040720E01
  1. Using SST, remove the companion flange.

    SST
    09950-30012   (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03040)

    NOTICE:
    Before using SST (center bolt), apply hypoid gear oil to its threads and tip.


4. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL

F040717E01
  1. Using SST, remove the oil seal.

    SST
    09308-10010  


5. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER

6. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING

F044343E01
  1. Using SST, remove the roller bearing (inner).

    SST
    09556-22010  

  1. W001770E02
    Using SST, tap out the roller bearing (outer).
    SST
    09308-00010  


7. REMOVE DIFFERENTIAL OIL STORAGE RING
  1. Using a screwdriver and hammer, tap out the oil storage ring.


8. REMOVE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER
← COMPONENTS (from Aug 2009)REMOVAL (from Aug 2009) →