REMOVAL
Removal / installation · Vehicles built from Aug 2009
Versions by build date: Jul 2007 – Jul 2009 from Aug 2009
| 1.
REMOVE REAR PROPELLER SHAFT ASSEMBLY |
 |
Remove the rear propeller shaft assembly (Click here).
| 2.
REMOVE REAR DRIVE PINION NUT |
 |
Using SST and a hammer, loosen the staked part of the rear drive pinion nut.
- SST
- 09930-00010
- NOTICE:
- Be sure to use SST with the tapered surface facing the shaft.
- Do not grind the tip of the SST with a grinder, etc.
- Completely loosen the staked part of the nut when removing it.
- Do not damage the threads of the drive pinion nut.
- Using SST to hold the companion flange.
- SST
- 09330-00021
(09330-00030)
Using a socket wrench (30 mm), remove the rear drive pinion nut.
| 3.
REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY |
 |
Using SST, remove the rear drive pinion companion flange sub-assembly.
- SST
- 09950-30012
(09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03040)
- NOTICE:
- Before using SST (center bolt), apply hypoid gear oil to its threads and tip.
| 4.
REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL |
 |
Text in Illustration
*1
|
Oil Seal
|
*2
|
Oil Slinger
|
Using SST, remove the rear differential carrier oil seal.
- SST
- 09308-10010
| 5.
REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER |
 |
- Remove the rear differential drive pinion oil slinger.
- NOTICE:
- Apply grease to the threads and tip of the SST center bolt before use.
| 6.
REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING |
 |
- Using SST, remove the rear drive pinion tapered roller bearing (inner).
- SST
- 09556-22010
- NOTICE:
- Apply grease to the threads and tip of the SST center bolt before use.
- Using SST, tap out the rear drive pinion tapered roller bearing (outer).
- SST
- 09308-55010
| 7.
REMOVE DIFFERENTIAL OIL STORAGE RING |
 |
- Using a screwdriver and hammer, remove the differential oil storage ring.
| 8.
REMOVE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER |
|