2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Jul 2014 from Aug 2014


INSPECT AIR-FUEL RATIO COMPENSATION SYSTEM

  1. Measure the voltage between the terminals of the ECM connectors.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    B2-22 (A1A-) - B3-1(E1)
    Ignition switch ON
    3.3 V
    B2-23 (A2A+) - B3-1(E1)
    Ignition switch ON
    3.3 V
    B2-30 (A1A+) - B3-1 (E21
    Ignition switch ON
    2.9 V
    B2-31 (A2A-) - B3-1(E1)
    Ignition switch ON
    2.9 V

    NOTICE:
    Connect test leads from the back side of the connector. Do not disconnect the connectors from the ECM.

    HINT:
    Voltage between the terminals of the ECM is kept constant regardless of the voltage of the A/F sensor.


    A121603E04

  1. Warm up the engine.

  1. Turn the ignition switch OFF.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON.

  1. Select the following menu items: Powertrain / Engine and ECT / Data List / AFS B1 S1 and O2S B1 S2.

  1. Warm up the A/F sensor with the engine speed at 2500 rpm for approximately 2 minutes.

  1. A118498E01
    Maintain the engine speed at 2500 rpm and confirm that the display on the intelligent tester, when AFS B1 S1 is selected, is as shown in the illustration.

    HINT:
    1. The display on the intelligent tester may slightly differ from the illustration.
    2. Only the intelligent tester displayed the waveform of the A/F sensor.

  1. Confirm that the waveform displays on the intelligent tester, when O2S B1 S2 is selected, changes between 0 V and 1 V with the engine speed at 2500 rpm.

    OK:
    The voltage output oscillates more than 8 times in 10 seconds.

    CAUTION:
    1. Perform the check immediately after warming up the engine.
    2. If the voltage variation could not be verified, warm up the heated oxygen sensor again. If it could not be verified even after warming up the sensor again, check the DTC No. (Click here)


INSPECT FUEL CUT-OFF RPM
  1. Increase the engine speed to at least 3500 rpm.

  1. Use a sound scope to check for injector operating sounds.

  1. Check that the injector operating sounds stop momentarily and then resume when the accelerator pedal is released.

    Fuel cut off rpm:
    2500 rpm

    Fuel return rpm:
    1200 rpm


VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

  1. A075917E01
    Check the appearance.

    1. Check if the indicated portions of the engine assembly are cracked, leaking or damaged.

      HINT:
      Disconnection of the engine oil level gauge, oil filler cap, PCV hose, etc. may cause the engine to run improperly. Disconnected, loose or cracked parts in the air induction system between the throttle body and cylinder head will allow air suction and cause the engine to run improperly.

      If necessary, repair the engine assembly.

← SYSTEM DIAGRAM (from Aug 2014)ON-VEHICLE INSPECTION (Aug 2009 – Jul 2014) →