2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Aug 2009 – Jul 2014

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Jul 2014 from Aug 2014


CHECK PURGE VSV
  1. Connect the intelligent tester to the DLC3.

  1. Remove the V-bank cover (Click here).

  1. A224686
    Disconnect the hose (connected to the canister) from the purge VSV.

  1. Start the engine and turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for EVAP Control.

  1. Check that a vacuum occurs at the VSV port.

    OK:
    Tester Operation
    Specified Condition
    EVAP VSV: OFF
    Purge VSV has no suction
    EVAP VSV: ON
    Purge VSV has suction

    If vacuum does not occur, check the following items.

    HINT:
    1. VSV (for canister purge)
    2. Clogging in the fuel vapor feed hose connecting the intake air surge tank and VSV
    3. Voltage from the ECM PRG terminal

  1. Exit the Active Test mode and connect the hose (connected to the canister) to the purge VSV.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.

  1. Warm up the engine and drive the vehicle.

  1. Confirm that the purge VSV opens.
    If the result is not as specified, replace the purge valve, wire harness or ECM.

  1. Install the V-bank cover (Click here).


INSPECT FUEL CUT-OFF RPM
  1. Start and warm up the engine.

  1. Increase the engine speed to at least 3500 rpm.

  1. Use a sound scope to check for injector operation noise.

  1. Check that when the accelerator pedal is released, injector operation noise stops momentarily and then resumes.
    If the result is not as specified, check the injector, wiring and ECM.


VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS
  1. Check that there are no cracks, leaks or damage.

    NOTICE:
    1. Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose and other components may cause the engine to run improperly.
    2. Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.

    If the result is not as specified, replace parts as necessary.


CHECK HOSES AND CONNECTORS
  1. Visually check for loose connections, sharp bends or damage.


CHECK FUEL TANK ASSEMBLY
  1. Visually check for deformation, cracks or fuel leakage.

← ON-VEHICLE INSPECTION (Jul 2007 – Jul 2009)ON-VEHICLE INSPECTION (from Aug 2014) →