2011-2016 FJ Cruiser · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. INSTALL PARKING BRAKE SWITCH
  1. Install the parking brake switch with the screw.


2. INSTALL PARKING BRAKE LEVER

D030033
  1. Install the parking brake lever and provisionally tighten the 2 bolts.

  1. G022567E01
    Install the center support and washer onto the parking brake lever.

  1. D030034
    Install the parking brake lever with the 4 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Install the straight pin into the parking brake lever.

  1. G022564E01
    Connect parking brake cables No. 2 and No. 3 to the parking brake pull rod.

  1. G022569
    Install the set spring, bush and parking brake pull rod with the adjusting nut.

  1. Connect the parking brake switch connector.


3. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)


4. ADJUST PARKING BRAKE LEVER TRAVEL

G022563
  1. Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.


5. INSTALL FRONT CONSOLE BOX

  1. B133852
    Engage the 3 clips and 2 claws and install the instrument lower cover.

  1. Install the 2 <F> bolts and 2 clips.


6. INSTALL BOX BOTTOM MAT

  1. B133899
    Install the box bottom mat.


7. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY

  1. B133897
    Engage the 3 claws and 5 clips and install the console upper rear panel.


8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

  1. B133896
    Install the shift lever knob.


9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)

  1. B133894
    Install the shift lever knob.


10. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY

B133901E01
  1. Slide the parking brake hole cover toward the rear of the vehicle and engage the 2 C claws.

  1. Engage the 4 claws and install the parking brake hole cover.


11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← REMOVAL (from Nov 2010)INSTALLATION (from Nov 2010) →