REMOVAL
Removal / installation · Vehicles built Jul 2007 – Oct 2010
Versions by build date: Jul 2007 – Oct 2010 from Nov 2010
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY
|
 |
Disengage the 2 A claws and 2 B claws.
Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.
| 3.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
|
 |
- Remove the shift lever knob.
| 4.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
 |
- Remove the shift lever knob.
| 5.
REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY
|
 |
- Shift the shift lever into the N position.
Disengage the 5 clips and 3 claws and remove the console upper rear panel.
| 6.
REMOVE BOX BOTTOM MAT
|
 |
- Remove the box bottom mat.
| 7.
REMOVE FRONT CONSOLE BOX
|
 |
- Remove the 2 clips and 2 <F> bolts.
Disengage the 3 clips and 2 claws and remove the instrument lower cover.
| 8.
REMOVE PARKING BRAKE LEVER |
 |
Release the parking brake lever.
Disconnect the parking brake switch connector.
- Remove the adjusting nut.
- Disconnect parking brake cables No. 2 and No. 3 from the parking brake pull rod.
Remove the parking brake pull rod, bush and set spring.
Remove the straight pin from the parking brake lever.
- Remove the washer.
Remove the 2 bolts and center support from the parking brake lever.
- Remove the 2 bolts and parking brake lever.
| 9.
REMOVE PARKING BRAKE SWITCH |
 |
Remove the screw and parking brake switch from the parking brake lever.