2011-2016 FJ Cruiser · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Jul 2007


1. INSTALL REAR DISC
  1. Align the matchmarks of the disc and axle hub and install the disc.


2. ADJUST PARKING BRAKE SHOE CLEARANCE

D028131E01
  1. Provisionally install the 2 hub nuts.

  1. Remove the hole plug, and turn the adjuster to expand the shoe until the disc locks.

  1. Contract the shoe adjuster until the disc rotates smoothly.

    Standard:
    Return 8 notches

  1. Install the hole plug.


3. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

C133098
  1. Install the disc brake caliper with the 2 bolts and 2 washers.

    Torque:
    105 N*m{ 1,071 kgf*cm , 78 ft.*lbf }


4. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 82 ft.*lbf }


5. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)


6. ADJUST PARKING BRAKE LEVER TRAVEL

G022563
  1. Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.

← REASSEMBLY (from Jul 2007)COMPONENTS (from Jul 2007) →