2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Jul 2007


1. INSTALL REAR AXLE HUB BOLT

G020976
  1. Install the washer and the nut onto a new hub bolt, as shown in the illustration.

  1. Using a screwdriver or the equivalent to hold the axle hub, install the hub bolt by tightening the nut.


2. APPLY HIGH TEMPERATURE GREASE
  1. Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.


3. INSTALL PARKING BRAKE SHOE

F041705E03
  1. Apply high temperature grease to the adjusting bolt and piece.

  1. Using needle-nose pliers, connect the parking brake cable to the parking brake shoe lever.

  1. D028128
    Install the No. 1 shoe, hold down spring pin, hold down compression spring and 2 hold down spring cups.

  1. Install the return tension spring and shoe adjusting screw set.

  1. Install the No. 2 shoe, hold down spring pin, hold down compression spring and 2 hold down spring cups.


4. INSTALL PARKING BRAKE SHOE STRUT
  1. Attach the compression spring and parking brake shoe strut to the No. 2 and No. 1 shoes.


5. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING

D028127
  1. Using needle-nose pliers, install the 2 return tension springs.

    HINT:
    First install the front side spring then install the rear side spring.


6. CHECK PARKING BRAKE INSTALLATION

  1. Check that each part is installed properly.

    D028130E01

    NOTICE:
    There should be no oil or grease adhering to the friction surfaces of the shoe lining or the disc.


7. INSTALL REAR DISC
  1. Align the matchmarks of the disc and axle hub and install the disc.


8. ADJUST PARKING BRAKE SHOE CLEARANCE

D028131E01
  1. Provisionally install the 2 hub nuts.

  1. Remove the hole plug, and turn the adjuster to expand the shoe until the disc locks.

  1. Contract the shoe adjuster until the disc rotates smoothly.

    Standard:
    Return 8 notches

  1. Install the hole plug.


9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

C133098
  1. Install the disc brake caliper with the 2 bolts and 2 washers.

    Torque:
    105 N*m{ 1,071 kgf*cm , 78 ft.*lbf }


10. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 82 ft.*lbf }


11. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)


12. ADJUST PARKING BRAKE LEVER TRAVEL

G022563
  1. Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.

← REMOVAL (from Jul 2007)COMPONENTS (from Jul 2007) →