2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

C133098
  1. Remove the 2 bolts and 2 washers and separate the disc brake caliper assembly.

    NOTICE:
    Suspend the disc brake caliper assembly with a piece of rope.


3. REMOVE REAR DISC
  1. Release the parking brake lever.

  1. D028126E05
    Place matchmarks on the disc and axle hub and remove the disc.

    HINT:
    If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.


4. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING

D028127
  1. Using needle-nose pliers, remove the 2 return tension springs.


5. REMOVE PARKING BRAKE SHOE STRUT
  1. Remove the parking brake shoe strut and compression spring.


6. REMOVE PARKING BRAKE SHOE

D028128
  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Disconnect the return tension spring and remove the No. 2 shoe.

  1. Remove the shoe adjusting screw set and return tension spring.

  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Using needle-nose pliers, disconnect the parking brake cable and remove the No. 1 shoe.


7. REMOVE REAR AXLE HUB BOLT

G020975E01
  1. Using SST and a screwdriver or the equivalent to hold the axle hub, remove the hub bolt.

    SST
    09650-17011  

← COMPONENTS (from Jul 2007)INSTALLATION (from Jul 2007) →