2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE REAR WHEEL

3. DRAIN BRAKE FLUID

HINT:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


4. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY

C133107E01
  1. Using SST, separate the brake tube.

    SST
    09023-00101  

    HINT:
    Use a container to catch the brake fluid.

  1. Remove the clip and flexible hose.

  1. C133098
    Remove the 2 bolts and 2 washers and remove the disc brake caliper assembly.


5. REMOVE REAR DISC
  1. Release the parking brake lever.

  1. D028126E05
    Place matchmarks on the disc and axle hub and remove the disc.

    HINT:
    If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.


6. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING

D028127
  1. Using needle-nose pliers, remove the 2 return tension springs.


7. REMOVE PARKING BRAKE SHOE STRUT
  1. Remove the parking brake shoe strut and compression spring.


8. REMOVE PARKING BRAKE SHOE

D028128
  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Disconnect the return tension spring and remove the No. 2 shoe.

  1. Remove the shoe adjusting screw set and return tension spring.

  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Using needle-nose pliers, disconnect the parking brake cable and remove the No. 1 shoe.


9. SEPARATE PARKING BRAKE CABLE

D028121E01
  1. Remove the 2 bolts and separate the parking brake cable from the parking brake plate.


10. REMOVE REAR SPEED SENSOR

C133069
  1. Disconnect the skid control sensor wire.

  1. Remove the nut and rear speed sensor.

    NOTICE:
    1. Do not attach any foreign matter to the sensor tip.
    2. Ensure that no foreign matter enters the sensor installation part.


11. REMOVE REAR AXLE SHAFT

F042741
  1. Remove the 4 nuts and rear axle shaft with parking brake plate.

  1. Remove the O-ring.


12. REMOVE REAR AXLE SHAFT OIL SEAL

F042742E01
  1. Using SST, remove the oil seal.

    SST
    09308-00010  

← COMPONENTS (from Jul 2007)DISASSEMBLY (from Jul 2007) →