DISASSEMBLY
Removal / installation · Vehicles built from Jul 2007
| 1. REMOVE REAR AXLE SHAFT SNAP RING |
![]() ![]() |
Using a snap expander, remove the snap ring.
| 2. REMOVE REAR AXLE SHAFT |
![]() ![]() |
Using SST and press, remove the rear axle shaft.
- SST
- 09521-25011
09521-25021
Remove the rear axle bearing inner retainer from the axle hub.
Remove the rear axle shaft washer from the axle hub.
Grind the rear axle bearing inner race surface using a grinder, then remove it with a chisel.

Remove the rear axle shaft oil seal from the rear axle shaft.
| 3. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY |
![]() ![]() |
Attach the 4 nuts to the housing bolts.
Using a hammer, remove the 4 housing bolts and rear axle hub and bearing assembly.
- NOTICE:
- Do not reuse the nuts previously removed from the vehicle.
| 4. REMOVE BRAKE DRUM OIL DEFLECTOR |
![]() ![]() |
Remove the deflector and deflector gasket to the rear axle shaft.
Using SST, remove the 6 hub bolts.
- SST
- 09650-17011




