2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

REASSEMBLY

Removal / installation · Vehicles built from Jul 2007


1. INSTALL BRAKE DRUM OIL DEFLECTOR

G020977E01
  1. Install a new deflector gasket and deflector onto the rear axle shaft.

    HINT:
    Align the 2 notches.

  1. G020973
    Install the washer and nut onto a new hub bolt, as shown in the illustration.

  1. Install the hub bolt by tightening the nut.


2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

F042777
  1. Position the parking brake plate on a new rear axle hub and bearing assembly and install the 4 housing bolts using 2 socket wrenches and a press.

    HINT:
    The left and right side bearing assemblies have different part numbers and are not interchangeable side to side.


3. INSTALL REAR AXLE SHAFT

G022121E01
  1. Install the washer and a new retainer onto the axle hub in the orientations shown in the illustration.

    NOTICE:
    1. Install the washer with its tapered surface facing downward.
    2. Install the retainer with its chamfered surface facing downward.

  1. Using SST and a press, install the rear axle shaft onto the rear axle hub and bearing.

    SST
    09631-12090  
    09726-40010  
    09951-01100  


4. INSTALL REAR AXLE SHAFT SNAP RING

F042773
  1. Using a snap ring expander, install a new snap ring.

← INSPECTION (from Jul 2007)INSTALLATION (from Jul 2007) →