ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jul 2007
| INSPECT FRONT WASHER NOZZLE |
Start the engine.
Check where the washer fluid hits the windshield.
- Standard:
- Washer fluid hits the windshield in the areas shown in the illustration.


- Specification:
Area
Measurement
A
45.5 mm (1.79 in.)
B
39 mm (1.54 in.)
C
32.5 mm (1.28 in.)
D
206 mm (8.11 in.)
E
191.5 mm (7.54 in.)
F
177 mm (6.97 in.)
G
335 mm (13.19 in.)
H
328 mm (12.91 in.)
I
320 mm (12.60 in.)
J
158 mm (6.22 in.)
K
170.5 mm (6.71 in.)
L
183.5 mm (7.22 in.)
- HINT:
- If the result is not as specified, replace the washer nozzle.
| INSPECT REAR WASHER NOZZLE (w/ Rear Wiper) |
Start the engine.
Check where the washer fluid hits the windshield.
- Standard:
- Washer fluid hits the windshield in the areas shown in the illustration.


- Specification:
Area
Measurement
A
26.5 mm (1.04 in.)
B
77 mm (3.03 in.)
C
129.5 mm (5.10 in.)
D
200 mm (7.87 in.)
E
113.5 mm (4.47 in.)
F
66 mm (2.60 in.)
G
98 mm (3.86 in.)
H
202.5 mm (7.97 in.)
I
231.5 mm (9.11 in.)
J
54.5 mm (2.15 in.)
K
74.5 mm (2.93 in.)
L
120.5 mm (4.74 in.)
- HINT:
- If the result is not as specified, adjust the washer nozzle.
| ADJUST REAR WASHER NOZZLE (w/ Rear Wiper) |
Using a screwdriver, adjust the direction of the rear washer nozzle.

- HINT:
- Use a thin-bladed screwdriver with an approximately 1 mm thick tip.
