REMOVAL
Removal / installation · Vehicles built from Jul 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE SPARE DISC WHEEL |
|
| 3.
REMOVE NO. 1 REAR SPOILER COVER
|
 |
Remove the 4 screws and No. 1 rear spoiler cover.
| 4.
REMOVE REAR SPOILER
|
 |
- Disconnect high mounted stop light connector.
Using a clip remover, remove the 3 clamps.
Remove the washer hose from the claw of the rear spoiler.
Disconnect the washer hose.
- Remove the 4 nuts.
| 5.
REMOVE BACK WINDOW SUPPORT LH
|
 |
Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and back window support.
- NOTICE:
- Do not touch the rod of the back window support with gloves, to avoid fibers from adhering.
- When foreign matter adheres to the rod, it prevents the rod from moving smoothly and reduces its holding power.
- HINT:
- Support the back door glass by hand while removing the back window support.
| 6.
REMOVE BACK WINDOW SUPPORT RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 7.
REMOVE BACK DOOR GLASS |
 |
Disconnect the 2 defogger connectors.
- Remove the 2 nuts and the back door glass.
| 8.
REMOVE BACK WINDOW STAY UPPER BRACKET RH |
 |
Remove the 2 screws, the retainer and the back window stay upper bracket.
| 9.
REMOVE BACK WINDOW STAY UPPER BRACKET LH |
 |
- HINT:
- Use the same procedure as described for the RH side.
| 10.
REMOVE BACK WINDOW LOCK STRIKER ASSEMBLY |
 |
Remove the 2 screws, the retainer and the back window lock striker.
| 11.
REMOVE BACK DOOR OUTSIDE HANDLE |
 |
Remove the screw and the back door outside handle.
Remove the bush.