2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


INSPECT CRANKSHAFT POSITION SENSOR

  1. A078431E43
    Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected:
    (Crankshaft Position Sensor)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Cold
    1630 to 2740 Ω
    Hot
    2065 to 3225 Ω

    NOTICE:
    In the table above, the terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

    If the resistance is not as specified, replace the sensor.

← INSPECTION (Jul 2007 – Jul 2009)INSTALLATION (Jul 2007 – Jul 2009) →