2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL ULTRASONIC SENSOR

  1. B138493
    Install the ultrasonic sensor with the retainer as shown in the illustration.

  1. Connect the ultrasonic sensor connector.


2. INSTALL REAR BUMPER COVER

  1. B135143
    Engage the 6 claws and the 2 clips and install the rear bumper cover.

  1. B135142
    w/ Back Sonar:

    1. Connect the 2 wire to wire connectors.

  1. B135141
    Tighten the 7 bolts and the 2 screws.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf } for bolt
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf } for screw

  1. B135140
    Remove the protective tape.


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← INSPECTION (from Jul 2007)INSTALLATION (Nov 2010 – Oct 2012) →