INSTALLATION
Removal / installation · Vehicles built Nov 2010 – Oct 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012
| 1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER |
Temporarily install the ultrasonic sensor retainer to the rear bumper.

Text in Illustration *1
Protrusion
*2
Keyhole
- NOTICE:
- Do not damage the rear bumper with the protrusion when installing the retainer.
- Securely install the ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.
- Do not damage the rear bumper with the protrusion when installing the retainer.
- HINT:
- When installing the retainer, align the keyhole and protrusion as shown in the illustration.
Engage the 2 claws to install the ultrasonic sensor retainer.
| 2. INSTALL NO. 1 ULTRASONIC SENSOR |
Engage the 2 claws to install the ultrasonic sensor.
- NOTICE:
- Push the ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.
Connect the connector.
| 3. INSTALL REAR BUMPER COVER |
