INSTALLATION
Removal / installation · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
| 1. INSTALL STEERING PAD SWITCH ASSEMBLY |
Engage the 4 claws and the 2 pins and install the steering pad.
Tighten the 2 screws.
- Torque:
- 2.4 N*m{ 24 kgf*cm , 21 in.*lbf }
Connect the connector and 3 guides.
w/ Cruise Control System:
Connect the cruise control switch connector.
| 2. INSTALL STEERING PAD |
Support the steering pad with one hand as shown in the illustration.

Connect the 2 connectors to the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Connect the horn connector.
Confirm that the circumferencial groove of the "Torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
Using "Torx" socket wrench (T30), tighten the 2 "Torx" screws.
- Torque:
- 8.8 N*m{ 90 kgf*cm , 78 in.*lbf }
- NOTICE:
- Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.
| 3. INSTALL STEERING WHEEL LOWER COVER LH |
Install steering wheel cover lower No.3.

| 4. INSTALL STEERING WHEEL LOWER COVER RH |
Install steering wheel cover lower No.2.

| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
| 6. INSPECT SRS WARNING LIGHT |
