2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. INSTALL STEERING PAD SWITCH

  1. B135137
    Engage the 2 claws and the pin and install the steering pad.

  1. Tighten the screw.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the connector.

  1. w/ Cruise Control System:

    1. Connect the cruise control switch connector.


2. INSTALL STEERING PAD

  1. C128255E01
    Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the circumferencial groove of the "Torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. Using "Torx" socket wrench (T30), tighten the 2 "Torx" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.


3. INSTALL STEERING WHEEL LOWER COVER LH

  1. C128195
    Install steering wheel cover lower No.3.


4. INSTALL STEERING WHEEL LOWER COVER RH

  1. C128196
    Install steering wheel cover lower No.2.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }


6. INSPECT SRS WARNING LIGHT
(Click here)
← INSPECTION (from Nov 2010)INSTALLATION (Nov 2010 – Jul 2012) →