2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier

Circuit diagnosis · Vehicles built from Nov 2010

DESCRIPTION

This circuit is used when an incoming cellular phone voice signal in the "Bluetooth" handsfree system is received.

WIRING DIAGRAM

E219920E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER)
  1. Disconnect the E43 radio receiver assembly and K13 stereo component amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E43-11 (IVO+) - K13-6 (INT+)
    Always
    Below 1 Ω
    E43-12 (IVO-) - K13-16 (INT-)
    Always
    Below 1 Ω
    E43-11 (IVO+) - Body ground
    Always
    10 kΩ or higher
    E43-12 (IVO-) - Body ground
    Always
    10 kΩ or higher
    E43-13 (SLD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter (from Nov 2010)Microphone Circuit between Microphone and Radio Receiver (from Nov 2010) →