Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
Circuit diagnosis · Vehicles built from Nov 2010
DESCRIPTION
The circuit is necessary for the Automatic Sound Levelizer (ASL) built into the stereo component amplifier assembly.Speed signals are received from the combination meter assembly and used for the ASL.
The ASL function automatically adjusts the sound volume in order to clear audio quality even when vehicle noise increases (as vehicle noise increases, the volume is turned up etc.).
- HINT:
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective system based on the pulse signal.
- If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the following diagram will not operate normally.
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective system based on the pulse signal.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) |
Check the output waveform.

Remove the combination meter assembly with the connector still connected (Click here).
Connect an oscilloscope to terminal E13-14 (+S) and body ground.
Turn the ignition switch ON.
Turn the wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
Item
Condition
Measurement terminal
E13-14 (+S) - Body ground
Tool setting
5 V/DIV., 20 ms./DIV.
Vehicle condition
Driving at approx. 20 km/h (12 mph)
- OK:
- The waveform is displayed as shown in the illustration.
Text in Illustration *a
Component with harness connected
(Combination Meter Assembly)
*b
Turn wheel
- HINT:
- When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - JUNCTION CONNECTOR) |
Disconnect the K13 stereo component amplifier assembly and E59 junction connector connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
K13-8 (SPD) - E59-6
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (JUNCTION CONNECTOR - COMBINATION METER ASSEMBLY) |
Disconnect the E59 junction connector and E13 combination meter assembly connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E59-5 - E13-14 (+S)
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
