INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2009 – Jul 2014 from Aug 2014
| 1. INSTALL SPARK PLUG |
Using a 16 mm spark plug wrench, install the 6 spark plugs to the cylinder head sub-assembly.
- Torque:
- 18 N*m{ 184 kgf*cm , 13 ft.*lbf }
| 2. INSTALL IGNITION COIL ASSEMBLY |
Install the 6 ignition coil assemblies to the cylinder head cover sub-assembly with the 6 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
Connect the 6 ignition coil assembly connectors.
| 3. INSTALL NO. 2 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System) |
| 4. INSTALL NO. 1 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System) |
| 5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE |
Install the air cleaner cap with the 4 hinges.

Install the No. 1 air cleaner hose with the clamp.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
Text in Illustration *a
Protrusion
*b
Groove
*c
Top
*d
Front
*e
RH
*f
Paint mark of the hose
Install the bolt.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
Connect the ventilation hose and vacuum hose.
- HINT:
- The direction of the hose clamp is indicated in the illustration.
Engage the 4 wire harness clamps.
Connect the MAF meter connector.
| 6. INSTALL V-BANK COVER |
Engage the 2 hooks to install the V-bank cover to the No. 1 V-bank cover bracket.
Align the 2 cushions of the V-bank cover with the 2 pins and press down on the V-bank cover to engage the 2 cushions to the 2 pins.
