2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


INSPECT MASS AIR FLOW METER

  1. A226617E01
    Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.
    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)

    OK:
    There is no foreign matter.

    If the result is not as specified, replace the mass air flow meter.

  1. A226758E01
    Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Mass Air Flow Meter)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (THA) - 2 (E2)
    -20°C (-4°F)
    13.6 to 18.4 kΩ
    1 (THA) - 2 (E2)
    20°C (68°F)
    2.21 to 2.69 kΩ
    1 (THA) - 2 (E2)
    60°C (140°F)
    0.49 to 0.67 kΩ

    If the result is not as specified, replace the mass air flow meter.

← INSPECTION (Jul 2007 – Jul 2009)INSTALLATION (Jul 2007 – Jul 2009) →