2011-2016 FJ Cruiser · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Aug 2009


1. REPLACE STRAIGHT PIN

HINT:
It is not necessary to remove a straight pin unless it is being replaced.

  1. Remove the straight pins.

    A224781E02

  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    Text in Illustration 
    *a
    Front Side:
    *b
    Rear Side:
    *c
    Upper Side:
    *d
    Lower Side:

    Standard Protrusion Height:
    Item
    Specified Condition
    Pin A
    22.5 to 23.5 mm (0.886 to 0.925 in.)
    Pin B
    10.5 to 11.5 mm (0.413 to 0.453 in.)
    Pin C
    8.5 to 9.5 mm (0.335 to 0.374 in.)
    Pin D
    5.5 to 6.5 mm (0.217 to 0.256 in.)


2. REPLACE TIGHT PLUG

HINT:
If coolant leaks from the tight plug or the plug is corroded, replace it.

  1. Remove the tight plugs.

  1. Apply adhesive around new tight plugs.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Using SST and a hammer, tap in the tight plugs to the standard depth.

    A221129E02

    Text in Illustration 
    *a
    LH Side:
    *b
    RH Side:
    *c
    Standard Depth
    -
    -
    SST
    09950-60010   (09951-00350)
    09950-70010   (09951-07150)

    Standard depth:
    0.2 to 1.2 mm (0.00787 to 0.0472 in.)

← INSPECTION (from Aug 2009)REASSEMBLY (from Aug 2009) →