2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010


1. INSTALL NO. 2 ECM BRACKET
  1. Install the No. 2 ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


2. INSTALL ECM BRACKET
  1. Install the ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL ECM
  1. Install the ECM with the 3 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the 6 connectors.


4. INSTALL 4 WHEEL DRIVE CONTROL ECU NO.2 (for Automatic Transmission 4WD)
  1. Install the four wheel drive control ECU with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.


5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

  1. B133856
    Install the glove compartment door assembly with the 3 hinges while holding it horizontal.

  1. B133854E01
    Slightly flex the upper part of the glove compartment door assembly, and install the glove compartment door assembly.

  1. Install the glove compartment door stoppers onto the glove compartment door.


6. PERFORM INITIALIZATION

NOTICE:
  1. Be sure to perform this procedure after reassembling the throttle body or removing and reinstalling any throttle body component.
  2. Perform the following procedure after replacing the ECM, throttle body or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.
  3. Be sure to perform this procedure after replacing the ECM and reconnecting the battery cable.

  1. Disconnect the cable from the negative (-) battery terminal. Wait at least 60 seconds and reconnect the cable.

  1. Turn the ignition switch to ON without operating the accelerator pedal.

    NOTICE:
    If the accelerator pedal is operated, perform the above steps again.

  1. Connect the intelligent tester to the DLC3 and clear the DTCs (Click here).

  1. Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

    Standard:
    Condition
    Engine Idle Speed
    A/C switched off
    580 to 680 rpm

    NOTICE:
    1. Be sure to perform this step with all accessories off.
    2. Make sure that the shift lever is in neutral.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

  1. Perform a road test and confirm that there are no abnormalities.

← INSTALLATION (Jul 2007 – Jul 2009)INSTALLATION (from Nov 2010) →