2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Aug 2012 – Oct 2012

Versions by build date: Jul 2007 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012

HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.


1. REMOVE REAR BUMPER COVER

  1. B190458E02
    Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. B198720
    Remove the clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B332240E01
    Remove the 7 bolts and the 2 screws.
    Text in Illustration 
    *1
    Bolt
    *2
    Screw

  1. B329571
    Disengage the wire harness clamp, and disconnect the connector.

  1. B190460
    Disengage the 6 claws and the 2 clips and remove the rear bumper cover.


2. REMOVE REAR BUMPER SIDE RETAINER RH

  1. E161885
    Remove the 3 screws and rear bumper extension retainer.


3. REMOVE REAR BUMPER SIDE RETAINER LH

HINT:
Use the same procedure as for the RH side.


4. REMOVE REAR FOG LIGHT ASSEMBLY LH (for LH Side)

E161251
  1. Disconnect the 2 connectors and wire harness clamp.

  1. Remove the 2 screws and rear fog light.


5. REMOVE REAR FOG LIGHT ASSEMBLY RH (for RH Side)

E161252
  1. Disconnect the 2 connectors and wire harness clamp.

  1. Remove the 2 screws and rear fog light.

← REMOVAL (Jul 2007 – Jul 2012)REMOVAL (from Nov 2012) →