REMOVAL
Removal / installation · Vehicles built from Nov 2012
Versions by build date: Jul 2007 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012
- HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
| 1.
REMOVE REAR BUMPER COVER
|
 |
- Apply protective tape as shown in the illustration.
Text in Illustration
*1
|
Protective Tape
|
- Remove the clip.
- Remove the 7 bolts and the 2 screws.
- Disengage the clamp and disconnect the connector.
- Disengage the 6 claws and the 2 clips and remove the rear bumper cover.
| 2.
REMOVE REAR BUMPER SIDE RETAINER RH |
 |
- Remove the 3 screws and rear bumper extension retainer.
| 3.
REMOVE REAR BUMPER SIDE RETAINER LH |
 |
- HINT:
- Use the same procedure as for the RH side.
| 4.
REMOVE REAR FOG LIGHT ASSEMBLY LH (for LH Side) |
 |
Disconnect the 2 connectors and wire harness clamp.
Remove the 2 screws and rear fog light.
| 5.
REMOVE REAR FOG LIGHT ASSEMBLY RH (for RH Side) |
 |
Disconnect the 2 connectors and wire harness clamp.
Remove the 2 screws and rear fog light.