2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

CB-10 System Microcomputer Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2012

Also covers:

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
CB-10
System microcomputer malfunction
  1. Multi-media interface ECU
  2. "iPod" or USB device
CB-11
Media interface microcomputer malfunction
CB-12
CD-LSI (large scale integration) malfunction

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

USB DEVICE OR "iPod" WAS DEFECTIVE


← CB-10 System Microcomputer Malfunction (+ CB-11, CB-12) (Nov 2010 – Jul 2012)CB-13 USB Over Current Detection (Nov 2010 – Jul 2012) →