2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

CB-13 USB Over Current Detection

Diagnostic trouble codes · Vehicles built from Aug 2012

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
CB-13
"iPod" or USB device" overcurrent malfunction
  1. "iPod" or USB device
  2. No. 1 stereo jack adapter assembly
  3. Harness or connector
  4. Multi-media interface ECU

WIRING DIAGRAM

E219786E01

INSPECTION PROCEDURE


1. REPLACE "iPod" OR USB DEVICE
  1. Disconnect the "iPod" or USB device from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good "iPod" or USB device to the No. 1 stereo jack adapter assembly.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
Go to step 4
OK

USB DEVICE OR "iPod" WAS DEFECTIVE

4. INSPECT MULTI-MEDIA INTERFACE ECU

  1. E194160E11
    Disconnect the E93 No. 1 stereo jack adapter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E93-1 (UPI) - E93-4 (UJSG)
    Always
    5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
Go to step 5
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)

5. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER)
  1. Disconnect the E94 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E94-1 (UPO) - E93-1 (UPI)
    Always
    Below 1 Ω
    E94-4 (UESG) - E93-4 (UJSG)
    Always
    Below 1 Ω
    E93-1 (UPI) - Body ground
    Always
    10 kΩ or higher
    E93-4 (UJSG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)


← CB-13 USB Over Current Detection (Nov 2010 – Jul 2012)CB-43 USB Device Class/Protocol Error (+ CB-44, CB-50, CB-51, CB-7D) (Nov 2010 – Jul 2012) →