2011-2016 FJ Cruiser · Service Manual BRAKE

C1409 Front Speed Sensor RH Performance

Diagnostic trouble codes · Vehicles built from Nov 2010

Also covers:

DESCRIPTION

Refer to DTCs C1401 and C1402 (Click here).
DTC Code
DTC Detection Condition
Trouble Area
C1409
C1410
One of the following conditions is met:
  1. When the vehicle is driven in reverse at a speed of 3 km/h (2 mph) or more and 3 of the wheel sensors detect the reverse signal, the other sensor detects a high frequency pulse 75 times while the ignition switch is ON.
  2. At a vehicle speed of 10 km/h (6 mph) or more, the vehicle speed sensor output drops by 50% for 5 seconds.
  3. The lowest wheel speed is 10 km/h (6 mph) or more and the difference between the highest and lowest wheel speed values is 2 km/h (1 mph) or less for 15 seconds.
  4. At a vehicle speed of 30 km/h (19 mph) or more, one wheel direction is different from the other 3 wheels for 1 second.
  5. At a vehicle speed of 100 km/h (62 mph), a reverse signal is output for 1 second or more.
  6. At a vehicle speed of 30 km/h (19 mph) or more, the rotation direction of one of the wheels is not detected normally and the rotation direction of the other 3 wheels is not the same for 1 second.
Front speed sensor RH/LH

HINT:
  1. DTC C1409 is for the front speed sensor RH.
  2. DTC C1410 is for the front speed sensor LH.


INSPECTION PROCEDURE

NOTICE:
Check the speed sensor signal after replacement (Click here).


1. REPLACE FRONT SPEED SENSOR
  1. Replace the front speed sensor (Click here).


NEXT

END


← C1407 Open or Short in Rear Speed Sensor RH Circuit (+ C1408) (from Aug 2012)C1411 Rear Speed Sensor RH Performance (+ C1412) (from Nov 2010) →