2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Nov 2012 – Jul 2014

Versions by build date: Nov 2012 – Jul 2014 from Aug 2014


INSPECT FUEL PUMP WITH FILTER ASSEMBLY

  1. A176427E01
    Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Pump with Filter Assembly)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    0.2 to 3.0 Ω

    If the result is not as specified, replace the fuel pump with filter assembly.

  1. A223267E02
    Connect the positive (+) lead of the battery to terminal 1 of the connector and the negative (-) lead to terminal 2. Check that the fuel pump with filter assembly operates.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Pump with Filter Assembly)
    If the result is not as specified, replace the fuel pump with filter assembly and fuel pump ECU.

    NOTICE:
    1. These tests must be performed within 10 seconds to prevent the coil from burning out.
    1. Keep the fuel pump with filter assembly as far away from the battery as possible.
    1. Always turn the voltage on and off on the battery side, not the fuel pump with filter assembly side.
    2. When the pump is locked and does not operate due to foreign matter being stuck, etc., replace the fuel pump ECU (Click here) together with the fuel pump with filter assembly, as the fuel pump ECU may be damaged electrically.

← DISASSEMBLY (from Nov 2012)INSPECTION (from Aug 2014) →