ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2009
| INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Inspect the oil control valve (for intake camshaft).
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1).
Operate the oil control valve using the intelligent tester, and then check the engine speed.
- OK:
Control Range
Specified Condition
OFF
Normal engine speed
ON
Rough idle or engine stalls (soon after oil control valve switched from OFF to ON)
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 2).
Operate the oil control valve using the intelligent tester, and then check the engine speed.
- OK:
Control Range
Specified Condition
OFF
Normal engine speed
ON
Rough idle or engine stalls (soon after oil control valve switched from OFF to ON)
Inspect the oil control valve (for exhaust camshaft).
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Exhaust Linear (Bank 1).
Operate the oil control valve using the intelligent tester, and then check the engine speed.
- OK:
Control Range
Specified Condition
-100%
Normal engine speed
100%
Rough idle or engine stalls (soon after oil control valve switched to 100%)
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Exhaust Linear (Bank 2).
Operate the oil control valve using the intelligent tester, and then check the engine speed.
- OK:
Control Range
Specified Condition
-100%
Normal engine speed
100%
Rough idle or engine stalls (soon after oil control valve switched to 100%)
