2011-2016 FJ Cruiser · Service Manual COMMUNICATION SYSTEM

Driving Support Switch Control ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Aug 2012

DESCRIPTION

Detection Item
Symptom
Trouble Area
Driving Support Switch Control ECU Communication Stop Mode
  1. "D-SEAT SW" not displayed on "Communication Bus Check" screen of intelligent tester
  2. Applies to "Driving Support Switch Control ECU Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of driving support switch control ECU
  2. Driving support switch control ECU branch wire or connector
  3. Driving support switch control ECU

WIRING DIAGRAM

E257638E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


NEXT


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


3. CHECK FOR OPEN IN CAN BUS WIRE (DRIVING SUPPORT SWITCH CONTROL ECU)
  1. Turn the ignition switch off.

  1. E257628E05
    Disconnect the driving support switch control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E96-8 (CANH) - E96-3 (CANL)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Driving Support Switch Control ECU)



NG
REPAIR OR REPLACE CAN BRANCH WIRE OR CONNECTOR (CAN-H, CAN-L)
OK


4. CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT SWITCH CONTROL ECU -)

  1. E257628E08
    Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E96-16 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E96-6 (+B) - Body ground
    Always
    11 to 14 V
    E96-2 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Driving Support Switch Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DRIVING SUPPORT SWITCH CONTROL ECU (Click here)


← Open in One Side of CAN Branch Line (from Aug 2012)