2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2014


INSPECT NO. 1 EMISSION CONTROL VALVE SET

  1. Check the resistance.

    1. A303235E01
      Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Emission Control Valve Set)

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (GND) - 5 (+B)
      20°C (68°F)
      4.5 to 5.5 Ω
      1 (GND) - Body ground
      Always
      1 MΩ or higher
      5 (+B) - Body ground

      NOTICE:
      When measuring the resistance, do not touch terminals 2, 3 or 4.

      HINT:
      When measuring the resistance make sure that the surface temperature of the No. 1 emission control valve set is 20°C.

      If the result is not as specified, replace the No. 1 emission control valve set.

  1. Check the operation of the No. 1 emission control valve set.

    1. A224403E04
      Check that air does not flow from port A to port B.
      Text in Illustration 
      *a
      Port A
      *b
      Port B
      *c
      Air
      *d
      Air does not Flow

      NOTICE:
      Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.

      If the result is not as specified, replace the No. 1 emission control valve set.

    2. A254426E01
      Apply battery voltage between the terminals of the No. 1 emission control valve set.
      Text in Illustration 
      *a
      Port A
      *b
      Port B
      *c
      Air
      *d
      Air Flows

      NOTICE:
      When applying voltage, do not touch terminals 2, 3 or 4.

    3. Check that air flows from port A to port B.

      OK:
      Condition
      Specified Condition
      Battery Positive (+) → 5 (+B)
      Battery Negative (-) → 1 (GND)
      Air Flows Out

      If the result is not as specified, replace the No. 1 emission control valve set.

← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →