Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > PRECAUTION

for Preparation Click here



1.INITIALIZATION

NOTICE:
  1. If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System (Click here).
  2. Perform the REGISTRATION (VIN registration) when replacing the ECM (Click here).
  3. Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM (Click here for 2WD, Click here for 4WD).
  4. If the ECM has been replaced or RESET MEMORY (AT initialization) has been performed, set up the function of the ATF (Automatic Transmission Fluid) temperature warning light (Click here for 4WD).

HINT:
  1. The engine learned value cannot be reset by disconnecting the battery negative (-) terminal or removing the EFI and ETCS fuses.
  2. Refer to Initialization to perform Learning Value Reset and idle learning (Click here).


2.FOR USING TECHSTREAM

CAUTION:
Observe the following items for safety reasons:
  1. Read its instruction books before using the Techstream.
  2. Prevent the Techstream cable from being caught on the pedals, shift lever and steering wheel when driving with the Techstream connected to the vehicle.
  3. When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the Techstream.