Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR


    A226977E01
  1. Install a new gasket to the sensor.
    Text in Illustration 
    *a
    New Gasket

  1. Using a 19 mm deep socket wrench, install the sensor.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    HINT:
    Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor (Click here).

  1. Connect the sensor connector.



2. INSTALL INTAKE MANIFOLD
  1. Install the intake manifold (Click here).