Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR

COMPRESSOR > REMOVAL

for Preparation Click here



1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.



    I102500E01
  1. Remove the caps from the service valves on the refrigerant line.

  1. Connect the refrigerant recovery unit.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

    NOTICE:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE FAN AND GENERATOR V BELT
  1. Remove the fan and generator V belt (Click here).



3. REMOVE FRONT FENDER APRON SEAL LH


I104023
  1. Remove the 5 clips and the front fender apron seal.



4. REMOVE FRONT FENDER REAR SPLASH SHIELD LH


I105372
  1. Remove the 5 clips and the front fender rear splash shield.



5. DISCONNECT NO. 2 ENGINE WIRE


I105373
  1. Remove the bolt and disconnect the ground wire.

  1. Disengage the clamp and disconnect the No. 2 engine wire.



    I105374
  1. Open the cover from terminal 30.

  1. Remove the 3 bolts and nut and disconnect the No. 2 engine wire.



6. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


I105348
  1. Remove the bolt and separate the suction hose.

  1. Remove the bolt and disconnect the suction hose.

  1. Remove the O-ring from the suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



7. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


I105349
  1. Remove the bolt and disconnect the discharge hose.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



8. REMOVE COOLER COMPRESSOR ASSEMBLY


I105350
  1. Disconnect the connector.

  1. Remove the 3 bolts and nut.

  1. Using a "TORX" socket wrench (E8), remove the stud bolt and the cooler compressor.