Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE AND DECELERATION SENSOR (for Automatic Transmission)
  1. Install the yaw rate and deceleration sensor with the 2 bolts.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Make sure that the sensor is at the correct angle when installing.

  1. Connect the yaw rate and deceleration sensor connector.

  1. Engage the clamp to the hole of the sensor bracket.



2. REMOVE YAW RATE AND DECELERATION SENSOR (for Manual Transmission)
  1. Install the yaw rate and deceleration sensor with the 2 bolts.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Make sure that the sensor is at the correct angle when installing.

  1. Connect the yaw rate and deceleration sensor connector.



3. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Engage the 3 claws and 5 clips and install the console upper rear panel.



4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133896
  1. Install the shift lever knob.



5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133894
  1. Install the shift lever knob.



6. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133901E01
  1. Slide the parking brake hole cover toward the rear of the vehicle and engage the 2 C claws.

  1. Engage the 4 claws and install the parking brake hole cover.



7. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(Click here)


8. CHECK VSC SENSOR SIGNAL
(Click here)