STEERING ANGLE SENSOR > INSTALLATION |
| 1. PRECAUTION |
| 2. INSTALL STEERING ANGLE SENSOR |
![]() |
Install the steering angle sensor.
![]() |
Connect the harness and steering angle sensor connector.
Connect the steering sensor connector.
| 3. INSTALL SPIRAL CABLE |
Check that the front wheels are facing straight ahead.
Set the turn signal switch in the neutral position.
![]() |
Install the spiral cable with the 4 screws.
![]() |
Connect the connectors to the spiral cable.
| 4. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Engage the claw and install the upper steering column cover.
| 5. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Engage the 2 claws.
Install the lower steering column cover with the 3 screws.
| 6. ADJUST SPIRAL CABLE |
Check that the ignition switch is turned to OFF.
Check that the negative (-) battery terminal is disconnected.
![]() |
Rotate the spiral cable counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
| 7. INSTALL STEERING WHEEL ASSEMBLY |
Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
Install the steering wheel assembly set nut.
| 8. INSPECT STEERING WHEEL CENTER POINT |
| 9. INSTALL STEERING PAD |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 connectors to the steering pad.
Connect the horn connector.
Confirm that the circumferencial groove of the "Torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
Using "Torx" socket wrench (T30), tighten the 2 "Torx" screws.
| 10. INSTALL STEERING WHEEL COVER LOWER NO.2 |
![]() |
Install steering wheel cover lower No.2.
| 11. INSTALL STEERING WHEEL COVER LOWER NO.3 |
![]() |
Install steering wheel cover lower No.3.
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 13. INSPECT STEERING PAD |
![]() |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Make sure that the horn sounds.
| 14. PERFORM INITIALIZATION |
| 15. INSPECT SRS WARNING LIGHT |