SEAT POSITION SENSOR > INSTALLATION |
| 1. PRECAUTION |
| 2. INSTALL SEAT POSITION SENSOR |
Check that the ignition switch is turned to OFF.
Check that the negative (-) battery terminal is disconnected.
![]() |
Install the seat position sensor with the bolt.
Check that there is no looseness in the installation parts of the seat position sensor.
Connect the connector to the seat position sensor.
| 3. INSTALL FRONT SEAT ASSEMBLY LH |
![]() |
Insert the 2 locating pins through the 2 body holes, place the front seat in the most rearward position and make sure that the inner and outer seat tracks are locked securely.
Tighten bolt 1 and then bolt 2 onto the front side.
Move the front seat to the most forward position, and then make sure that the inner and outer seat tracks are locked securely.
Tighten bolt 3 and then bolt 4 onto the rear side.
Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.
![]() |
for Driver Side:
Connect the 2 buckle switch connectors.
w/ Front Seat Side Airbag:
Install the clamp.
![]() |
for Front Passenger Side:
Connect the connector.
w/ Front Seat Side Airbag:
Install the clamp.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 6. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).