Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. INSTALL SIDE AIRBAG SENSOR LH
  1. Check that the ignition switch is turned to OFF.

  1. Check that the negative (-) battery terminal is disconnected.

    CAUTION:
    After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.



    C128265
  1. Install the side airbag sensor LH with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the side airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the side airbag sensor LH, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the side airbag sensor LH.



    C128264E01
  1. Connect the connector to the side airbag sensor LH.



3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B130604E02
  1. Align the locating marks with the paint marks first, and install the front door opening trim weatherstrip, as shown in the illustration.
    Text in Illustration 
    *a
    Locating Mark
    *b
    Paint Mark

    Paint mark:
    Area
    Color
    RH side
    White
    LH side
    Red



4. INSTALL ACCESS DOOR SCUFF PLATE LH


    B130598
  1. Engage the 6 claws and install the access door scuff plate.



5. INSTALL FRONT DOOR SCUFF PLATE LH


    B130597
  1. Engage the 14 claws and install the door scuff plate.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when the cable has been disconnected from the negative battery terminal.



8. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).