Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. INSTALL FRONT AIRBAG SENSOR LH
  1. Check that the ignition switch is turned to OFF.

  1. Check that the negative (-) battery terminal is disconnected.

    CAUTION:
    After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.



    C141567E01
  1. Connect the connector to the front airbag sensor LH.



    C128245
  1. Install the front airbag sensor LH with the 2 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the front airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
    2. When installing the front airbag sensor LH, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the front airbag sensor LH.



3. INSTALL FRONT BUMPER COVER
  1. Install the 4 clips.

  1. Engage the 2 claws and install the front bumper cover.



    B134732
  1. Install the 8 screws and the 4 bolts.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf } for screw
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf } for bolt

  1. Install the 5 clips.

  1. Remove the protective tape.



4. INSTALL RADIATOR GRILLE
  1. Engage the 5 clips and install the radiator grille.

  1. Install the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Install the 2 clips.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when the cable has been disconnected from the negative battery terminal.



7. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).