Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    C128215E01
  1. Engage the 5 hooks.

  1. Engage the 5 hooks and install the front passenger airbag assembly onto the instrument panel.



    C128213
  1. Install the 2 screws.



3. INSTALL DEFROSTER NOZZLE ASSEMBLY


    B133875
  1. Engage the 9 claws and install the defroster nozzle.

  1. Install the 5 <B> screws.



4. INSTALL NO.1 SIDE DEFROSTER NOZZLE DUCT


    B133874
  1. Engage the 2 claws and install the side defroster nozzle duct.

  1. Install screw <B>.



5. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY


    C128256E01
  1. Install the 3 clamps.

  1. Connect the 2 connectors to the front passenger airbag assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



6. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

HINT:
Refer to the procedures from "INSTALL INSTRUMENT PANEL SUB-ASSEMBLY" (Click here).



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



8. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization after reconnecting the cable to the negative battery terminal.



9. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).