Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

HINT:
Refer to the procedures up to "REMOVE INSTRUMENT PANEL SUB-ASSEMBLY" (Click here).



4. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY
  1. Remove the 3 clamps.



    C128212E01
  1. Disconnect the 2 connectors from the front passenger airbag assembly.



5. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    B133874
  1. Remove screw <B>.

  1. Disengage the 2 claws and remove the side defroster nozzle duct.



6. REMOVE DEFROSTER NOZZLE ASSEMBLY


    B133875
  1. Remove the 5 <B> screws.

  1. Disengage the 9 claws and remove the defroster nozzle.



7. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    C128213
  1. Remove the 2 screws.



    C128214E01
  1. Using a screwdriver (with its tip wrapped in protective tape), disengage the 5 hooks from the instrument panel and turn the front passenger airbag assembly in the direction indicated by the arrow shown in the illustration.

  1. Disengage the 5 hooks and remove the front passenger airbag assembly from the instrument panel.